Victron Automotive IP65 Charger 12V/4A – 12V/1A with DC connector

Beskrywing

Produkbesonderhede

About the Victron Automotive IP65 Charger 12V/4A – 12V/1A with DC connector

This charger has been designed for charging a variety of 12V lead acid batteries, such as WET, GEL and AGM, which are widely used for cars, motorcycles and other vehicles. Battery capacities range from 1,2Ah to 120Ah. Full protection against reverse polarity and short-circuiting ensures that the charging operation is much safer. The charger will wait until a charging mode has been selected before a connected battery can be charged.

DC connector

Depending on the application, clamps, eyelets or a cigarette plug (all included) can be connected to the charger.

Less maintenance and aging when the battery is not in use: the Storage Mode

The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 13,2 V to minimize gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.

Protected against overheating and reverse polarity connection

The output current will reduce as temperature increases up to 40°C, but the charger will not fail. Output relay protects against reverse polarity connection.

Five LED’s for status and mode indication

When connected to the AC supply the STAND-BY LED will turn on. No voltage will be present at the output. After connection to a battery (battery voltage must exceed 8,5V), a choice can be made out of three charge profiles with the MODE button:

1. Current limited t0 0,8A and 14,4V absorption voltage. The red LED <14Ah will be on.

2. Current 4A and 14,4V absorption voltage. The red LED >14Ah will be on. Application: Flooded, AGM or GEL batteries. Ambient temperature 10-35 ° C.

3. Current 4A and 14,7V absorption voltage. The red LED COLD will be on. Application:

   Flooded, AGM or GEL batteries. Ambient temperature below 10 ° C, or batteries requiring a higher charge voltage (OPTIMA spiral cell batteries for example).

Until the battery is fully charged, the red LED CHARGE will be on. After completion of the charge process, the red LED FULL will be on.

In case of reverse polarity connection, the red LED ! will be on
If the red LED STANDBY remains on, even after pressing the MODE button, the connection to the battery is  interrupted.

Specifications

• Input voltage: 220 – 240VAC, 50/60HZ
• Input current: 0,7A rms maximum
• Battery drain current: 5mA maximum (with no input power) Cut-off voltage: 14,4V or 14,7V
• Charging current: 4A or 0,8A
• Ripple: 150mV maximum
• Battery type: 12V lead acid battery, 1,2Ah – 120Ah Protection level: IP65

Downloads

Manual

Data Sheet

ISO9001  certificate 

Specifications

Fitment

Supplied for fitting by you, your mechanic or a 4×4 fitment centre. Not sure it suits your vehicle? Email info@veldkraft.co.za with the make, model and year before you order.